Updated November 2026

An ef ecoflow power station can keep a refrigerator, a CPAP machine and a sump pump running through a typical outage, but only if you size it correctly. This guide shows you how to total the watt-hours your essential loads need, add a safety margin, and estimate how many hours the unit will last. The math takes about ten minutes once you have the nameplate numbers in hand.

Step 1: Find the Wattage of Each Device

Start with the label on each appliance or the manufacturer’s specification sheet. Look for watts (W) or amps (A) and voltage (V). If you only see amps, multiply amps by volts to get watts. Write down two numbers for each device: its running wattage and its startup (surge) wattage, which motors like sump pumps and compressors draw briefly when they start.

Shopping for one? See our guide: 3 Best Ef Ecoflow Portable Power Station River 2 Pros (2026): Our Picks.

Step 2: Convert Usage into Watt-Hours

Watt-hours (Wh) measure how much energy a device uses over time. Multiply running watts by the hours you expect to run it per day. A refrigerator rated at 150 W that runs about 8 hours a day uses roughly 1,200 Wh daily, though compressors cycle on and off, so real use is often lower. A CPAP machine drawing 60 W for 8 hours of sleep uses about 480 Wh. A sump pump drawing 800 W for 15 minutes an hour during heavy rain adds a few hundred Wh over a long event.

Step 3: Build Your Essential Load List

Include only the loads you need during an outage. Here is a simple worksheet you can copy:

  1. List every essential device with its running watts.
  2. Estimate daily hours of use for each device.
  3. Multiply watts by hours to get daily Wh.
  4. Add the daily totals for your target number of backup days.
  5. Add 20 percent for conversion losses and battery aging.
Device Running W Hours/Day Daily Wh
Refrigerator 150 8 1,200
CPAP machine 60 8 480
Sump pump (intermittent) 800 1 800
LED lights and phone charging 50 4 200

Step 4: Compare Your Total to Station Capacity

Divide your adjusted total by the station’s rated capacity to estimate runtime in hours. Remember that inverter losses and the unit’s usable capacity are lower than the printed Wh figure, so treat the result as a conservative estimate. Check that the station’s continuous output rating covers your running load and its surge rating covers the sump pump’s startup draw. If either is short, you need a larger unit or fewer devices on at once.

For a deeper look at runtime math, see Ecoflow Home Power Station: How to Size One for Outages (2026) and Ecoflow Delta 3 Series Portable Power Station: Sizing for Home Backup (2026).

Tips and Common Mistakes

  • Do not size only for the refrigerator. Sump pumps and CPAP machines often drive the real requirement.
  • Plan for at least one full day of backup, and more if you live where outages last longer.
  • Recharge options matter. Solar input or a vehicle charger can extend runtime far beyond the battery alone.
  • Keep the station out of direct sun and enclosed spaces, and follow the manufacturer’s ventilation guidance.
  • Test the full setup once before you need it, including the transfer switch or plug-in path you plan to use.

Compare models before you buy, including the Ef Ecoflow Portable Power Station Delta 2: What It Runs and How Long It Lasts and EF EcoFlow Portable Power Station 3600Wh Delta Pro: 4 Best Options (2026).

  • Kill-A-Watt style plug-in power meter: Shows the real draw of a refrigerator or pump so you can replace guesses with measured numbers. View on Amazon
  • Heavy-duty extension cord rated for outdoor use: Lets you run devices safely from the station to where they are needed. View on Amazon

FAQ

How many watt-hours do I need to run a refrigerator overnight?

A typical refrigerator often uses between 500 and 1,500 Wh per day, depending on its efficiency, temperature setting and how often the door opens. Measure your own unit with a plug-in power meter for the most accurate figure.

Can an ef ecoflow power station run a sump pump?

Many units can, provided their surge rating covers the pump’s startup draw. Confirm the pump’s locked rotor amps and the station’s surge specification, and consult an electrician if you are unsure.

Does the printed capacity equal usable runtime?

No. Conversion losses and battery management reduce usable energy, so plan for roughly 80 to 85 percent of the rated figure. Always build in a margin.

Conclusion

Sizing an ef ecoflow power station comes down to listing essential loads, converting them into daily watt-hours, and adding a safety margin. Check surge ratings for motor-driven devices, and test your setup before an outage arrives. For medical devices such as CPAP machines, confirm your backup plan with your provider or a qualified professional.

Emily Parker

About Emily Parker

Emily Parker is part of our editorial team and reviews and edits our solar generators for home backup & emergencies guides, checking product details against manufacturer specifications and owner feedback.