Updated November 2026
A jackery 3600 watt solar generator can keep essential home loads running through a power outage, but only if you match its capacity to what you actually plug in. This guide shows you how to total your critical devices in watt-hours, estimate how long the unit will last, and decide whether solar recharging fits your situation. Work through the numbers before you buy, because the wattage rating alone tells you very little about runtime.
Understand the Difference Between Watts and Watt-Hours
The “3600 watt” figure in the name refers to output power, meaning how much a generator can supply at one moment. Runtime depends on watt-hours (Wh), which measures stored energy. A device drawing 100 watts for 10 hours uses 1,000 Wh, regardless of how large the generator’s output rating is. Manufacturers list battery capacity in Wh, so check that number on the spec sheet before comparing models.
Shopping for one? See our guide: Jackery HomePower 3600 Plus Solar Generator: 5 Best Picks Compared (2026).
Calculate Your Critical Load in Watt-Hours
Start by listing only the devices you need during an outage. Typical examples include a refrigerator, a CPAP machine, a sump pump, a router and a few lights. For each item, find its running wattage on the label, then multiply by the hours you expect to use it per day.
- Write down each device and its running wattage (look for the label or the manual).
- Estimate daily hours of use. A refrigerator cycles on and off, so its average draw is often well below its label rating.
- Multiply watts by hours to get daily watt-hours for each device.
- Add the totals together, then add roughly 15 to 20 percent for conversion losses in the inverter.
- Compare the result to the unit’s usable capacity, not its rated capacity.
Example: Refrigerator, CPAP and Sump Pump
A typical household refrigerator might average around 100 to 150 Wh per day in real use. A CPAP machine often draws about 30 to 60 watts for 8 hours, roughly 240 to 480 Wh per night. A sump pump may run only briefly but draws high surge current when it starts. Totals vary widely by model, so check your own appliance labels and your pump’s start-up requirements.
| Device | Typical Running Watts | Hours per Day (Estimate) | Approximate Daily Wh |
|---|---|---|---|
| Refrigerator | About 100 to 150 average | 24 (cycling) | About 100 to 150 |
| CPAP machine | About 30 to 60 | 8 | About 240 to 480 |
| Sump pump (intermittent) | About 800 while running | 0.5 to 1 | About 400 to 800 |
| Wi-Fi router and modem | About 20 | 24 | About 480 |
Plan for Solar Recharging
A solar panel array does not recharge a battery at its full rated output all day. Weather, panel angle and time of day all reduce actual input. Many owners plan on a fraction of the panels’ nameplate rating as a realistic daily average, then size their array so that daily solar input at least matches daily use. If your outages are short, grid or generator recharging may matter more than solar. Read the guide on Jackery Solar Generator 7200 Watt: What It Can Power and How to Size It for a comparison of larger-capacity sizing, and see Jackery Solar Generator Kit: How to Choose and Size One for Home Backup (2026) for kit-level planning.
Check Surge Requirements for Motor Loads
Motors, including sump pumps and well pumps, draw several times their running wattage when they start. Confirm that the generator’s surge rating exceeds your pump’s start-up draw. If you are unsure, ask a licensed electrician to verify the load before you rely on the unit during a flood. For more context on small units and their limits, see What Can a 300 Watt Solar Generator Run? Devices and Runtime.
Recommended gear
A few accessories make a real difference when you set up for backup power.
- A plug-in watt meter helps you measure actual consumption for each appliance instead of relying on label estimates. View on Amazon
- Heavy-gauge extension cords rated for outdoor or high-load use reduce voltage drop over longer runs. View on Amazon
- A solar panel mounting kit with adjustable tilt helps you aim panels toward the sun across seasons. View on Amazon
Common Mistakes and Tips
- Sizing to the rated Wh instead of usable capacity, which is lower after inverter and battery limits.
- Ignoring the sump pump’s start-up surge and assuming running wattage is enough.
- Forgetting that a refrigerator runs longer in hot weather and opening the door less often helps.
- Assuming full solar output all day. Plan around partial sun and cloudy days.
- Skipping a test run. Simulate an outage once to confirm runtime before you need it.
FAQ
How long will a jackery 3600 watt solar generator run a refrigerator?
Runtime depends on the refrigerator’s average daily consumption and the unit’s usable capacity. Divide usable Wh by your fridge’s daily Wh to estimate hours or days. Check your appliance’s energy label for a more accurate daily figure.
Can it run a CPAP machine overnight?
Many CPAP machines draw modest wattage for roughly eight hours, so a single night is often within reach for a unit of this size. Confirm your machine’s draw and your battery’s usable capacity, and consult your sleep provider or equipment supplier about backup planning.
Is solar charging enough to keep up with daily use?
It depends on your panel count, sun exposure and daily consumption. Plan for conservative daily solar input, and if your needs exceed it, supplement with grid or generator charging.
Conclusion
A jackery 3600 watt solar generator is most useful when you size it from your own critical loads in watt-hours, not from its output rating. Total your essential devices, add a margin for losses, and check motor surge requirements. Test the setup before an outage arrives, and consult a licensed electrician for any permanent wiring or sump pump connection.

