Updated November 2026

A solar generator power bank is a portable battery station that stores electricity from wall outlets or solar panels and releases it to run household devices during an outage. This guide shows you how to estimate what you need, convert appliance wattage into watt-hours, and choose a unit that will keep essentials running for as long as you need. By the end, you will have a simple sizing worksheet you can reuse for any backup plan.

What a Solar Generator Power Bank Actually Does

People often use “power bank” to describe the small USB battery packs that charge phones. A solar generator power bank is a larger version of the same idea. It contains a lithium battery, an inverter that converts stored direct current into 120-volt alternating current, and a set of outlets. Most units also accept solar input through a dedicated port, and many can recharge from a standard wall outlet when the grid is working.

Shopping for one? See our guide: Jackery Solar Generator Home Power 3000: 4 Best Options Compared (2026).

The practical difference from a gas generator is that it runs silently, produces no exhaust, and can be used indoors. The tradeoff is capacity. A battery holds a fixed amount of energy, so the question is always how long it can carry a given load.

Step 1: List the Devices You Need to Keep Running

Start with a short list of essentials rather than the whole house. Most households only need three or four loads during an outage: a refrigerator, a medical device if one applies, a sump pump or well pump, a router and a few lights or phone chargers.

  1. Write down each device by name.
  2. Check the label or manual for its running wattage and, if listed, its starting (surge) wattage.
  3. Estimate how many hours per day it runs. A refrigerator cycles on and off, so its real daily use is far lower than its peak draw.
  4. Mark which devices are critical and which are optional.

Step 2: Convert Wattage Into Watt-Hours

Battery capacity is rated in watt-hours (Wh). To find out how much energy a device uses in a day, multiply its average watts by the hours it runs.

Formula: Daily watt-hours = average watts × hours of use per day

Here are worked examples using typical figures. Your actual numbers will vary by model and usage.

Device Typical Running Watts Assumed Hours Per Day Approximate Daily Watt-Hours
Refrigerator (average, cycling) 100–150 W average 24 (cycling) About 1,200–1,400 Wh
CPAP machine 30–60 W 8 About 240–480 Wh
Sump pump (1/3 HP) 500–800 W while running 1 (short cycles) About 500–800 Wh
Wi-Fi router and modem 10–20 W 24 About 240–480 Wh
LED lights (5 bulbs) 40 W total 5 About 200 Wh

Add the daily totals for your critical devices. If your list adds up to 2,000 Wh per day, a battery rated near 2,000 Wh will last roughly one day in theory. In practice, you should plan for less than the full rating because of conversion losses.

Account for Inverter and Conversion Losses

Every time energy passes through an inverter, some is lost as heat. Manufacturers commonly specify inverter efficiency in the range of roughly 85 to 90 percent. A simple way to stay safe is to divide the battery’s rated watt-hours by about 0.85 to estimate usable runtime for AC loads. For a 2,000 Wh unit, plan on about 1,700 Wh of useful output.

Check Surge Requirements

Motors draw a short burst of extra power when they start. Refrigerators, sump pumps and well pumps are the usual culprits. Confirm that the power bank’s continuous rating covers the running watts and that its surge rating covers the starting watts. If it does not, the unit will shut down when the motor kicks on. The companion article Surge vs Continuous Power: What Your Solar Generator Can Actually Start walks through this check in more detail.

Step 3: Estimate How Long You Need to Run

Decide how many hours of backup you want before choosing a unit. For most outages, a few hours of essentials is enough. For multi-day events, you will need either more battery capacity or a way to recharge.

  • Short outage (under 8 hours): Focus on lights, a phone, a router and a medical device if needed.
  • One day: Add the refrigerator and cycle it with the door closed.
  • Several days: Plan on solar recharging, and size panels so they can replenish a meaningful share of the daily load.

Solar recharging depends on sunlight. Panels typically deliver their rated output only for a few peak hours per day, so a 400-watt panel array might produce roughly 1,200 to 1,600 Wh on a good day in many regions, and less in cloudy weather. Treat these as rough planning numbers and verify with your local conditions.

Step 4: Choose a Unit With Room to Spare

Once you know your daily watt-hours and your target runtime, pick a unit with capacity above your estimate. A margin of 20 to 30 percent covers hot weather, cold weather that reduces battery output, and the reality that devices often run longer than planned.

Look at these specifications on the product page:

  1. Battery capacity in watt-hours.
  2. Continuous AC output in watts.
  3. Surge rating in watts.
  4. Number and type of outlets, including 120-volt AC, USB and 12-volt DC.
  5. Maximum solar input in watts and the input voltage range.
  6. Battery chemistry. Lithium iron phosphate (LiFePO4) is widely specified for long cycle life.

Tips for Using a Solar Generator Power Bank in an Outage

  • Charge the unit to full before storms are forecast, and keep it topped up during mild weather.
  • Use the refrigerator’s own thermostat settings and keep the door closed to reduce cycling.
  • Run the sump pump only when needed and test it once to confirm the surge rating is adequate.
  • Keep the unit in a dry, ventilated spot away from direct heat, and never place it in a closed cabinet while charging.
  • Check battery state of charge every few hours and shut off non-essential loads early.

Common Mistakes When Sizing a Solar Generator Power Bank

  • Using the refrigerator’s nameplate wattage for hourly use. The compressor cycles, so daily energy is what matters.
  • Ignoring surge wattage. A unit that powers a fridge when running may still fail when the compressor starts.
  • Forgetting conversion losses. Rated watt-hours are never fully usable for AC loads.
  • Assuming full sun every day. Cloudy stretches can cut solar recharging sharply.
  • Trying to back up the whole house. Focus on essentials first, then expand if you need more.

These items support the sizing and setup steps above. Confirm compatibility with your specific unit before buying.

  • Plug-in watt meter: Measures real running and surge draw of a device so you can replace guesses with readings. View on Amazon
  • Portable solar panel kit: Adds daytime recharging for multi-day outages. Check the panel’s rated watts and the unit’s maximum solar input before pairing. View on Amazon
  • Heavy-duty extension cord rated for outdoor use: Lets you reach a sump pump or fridge without overloading the outlet. Choose a gauge suited to the load. View on Amazon

FAQ

How many watt-hours do I need to run a refrigerator?

A typical full-size refrigerator often uses roughly 1,000 to 1,500 watt-hours per day, depending on its age, size, ambient temperature and how often you open the door. Measuring with a plug-in meter over 24 hours gives the most accurate figure for your appliance.

Can a solar generator power bank run a CPAP machine overnight?

Many CPAP machines draw roughly 30 to 60 watts, so an eight-hour night may use a few hundred watt-hours. Check your device’s specifications and the unit’s rated output. For medical equipment, consult your sleep specialist or equipment supplier about backup planning. Our article Using a Solar Generator or Power Station for a CPAP Machine covers this in more depth.

Will a sump pump start on a portable battery unit?

It depends on the pump’s starting current and the unit’s surge rating. Check both numbers before relying on the setup. A small sump pump often needs a surge rating well above its running watts. If you are unsure, consult a licensed electrician.

Does solar charging work on cloudy days?

Solar panels still produce some power in cloudy conditions, but output drops significantly. Plan for lower daily recharging on overcast days, and treat solar as a supplement rather than a guarantee.

What is the difference between watts and watt-hours?

Watts measure how much power a device draws at any moment. Watt-hours measure how much energy is used over time. A 100-watt device running for 10 hours uses 1,000 watt-hours.

Can I charge the unit from a car or generator?

Many units accept input from a wall outlet, a vehicle’s 12-volt port or a gas generator, in addition to solar panels. Check the input specifications for maximum wattage and voltage range before connecting anything.

How long do lithium batteries in these units last?

Manufacturers often specify cycle life in terms of charge cycles retained at a certain percentage of original capacity. Storing the unit at moderate temperatures and avoiding repeated deep discharges helps preserve capacity. Follow the manual’s storage guidance.

Is a solar generator power bank safe to use indoors?

Because these units produce no combustion exhaust, they are generally used indoors in ventilated areas. Keep them away from water, avoid blocking vents, and follow the manufacturer’s safety instructions. For wiring a unit into your home electrical system, consult a licensed electrician.

Conclusion

A solar generator power bank can keep essential loads running during an outage if you size it correctly. Start by listing critical devices, convert their wattage into daily watt-hours, and add margin for conversion losses and surge demands. With those numbers in hand, choosing a unit and setting realistic expectations becomes straightforward.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our solar generators for home backup & emergencies guides, checking product details against manufacturer specifications and owner feedback.