Updated November 2026
The EcoFlow Delta Pro 3600 W is a portable power station built to keep essential home circuits running during an outage. This guide shows you how to total the loads you actually need, estimate how long the unit will last, and decide whether it fits your situation. The method is simple: list your devices, convert their power draw into watt-hours, and compare that number against the unit’s capacity.
Step 1: List the Loads You Need to Keep Running
Start with the devices that matter most during an outage. For most households that means a refrigerator, a CPAP machine, a sump pump, a router and a few lights. Skip the electric range, dryer and central air unless you have a generator-scale plan, since those loads will drain any portable station quickly.
Shopping for one? See our guide: 7 Best EcoFlow Delta Pro Ultra Battery Options Compared (2026).
Step 2: Convert Each Device Into Watt-Hours
Watt-hours (Wh) equal the device’s wattage multiplied by the hours it runs per day. Check the label or manual for the wattage. If the label lists only amps, multiply amps by volts (usually 120 V in the US). Refrigerators cycle on and off, so their real consumption is often well below their peak rating. A typical efficient fridge may average roughly 100 to 150 Wh per day, while a CPAP often uses about 30 to 60 Wh overnight, depending on the model and humidifier settings. Sump pumps draw heavy current only while running, so estimate the number of pump cycles per hour during a storm.
| Device | Typical Running Watts | Example Daily Use | Approximate Daily Wh |
|---|---|---|---|
| Refrigerator | 100 to 200 W | Cycles about 8 hours per day | About 100 to 150 Wh |
| CPAP machine | 30 to 60 W | 8 hours overnight | About 240 to 480 Wh (check your model) |
| Sump pump (1/3 HP) | About 800 W while running | 10 minutes per hour for 6 hours | About 800 Wh |
| Wi-Fi router and modem | 10 to 20 W | 24 hours | About 240 to 480 Wh |
These figures are ranges for planning only. Use the nameplate data on your own appliances, and confirm CPAP and pump numbers with your equipment manuals or a qualified installer.
Step 3: Add a Safety Margin and Compare to Capacity
Add your daily watt-hour totals, then add roughly 20 to 30 percent for inverter losses and battery aging. The EcoFlow Delta Pro 3600 W’s stored energy capacity is the figure to compare against. If your adjusted total exceeds the usable capacity, you will need either fewer loads, a larger battery expansion, or solar input to recharge during a longer outage.
Also check the surge rating. Sump pumps and some compressors draw several times their running wattage at startup, so confirm the unit’s continuous and surge outputs can handle your heaviest device.
Common Mistakes to Avoid
- Sizing only for the device label instead of the daily runtime.
- Ignoring inverter losses, which can consume a meaningful share of stored energy.
- Forgetting startup surge on motors such as sump pumps.
- Running the station indoors without adequate ventilation.
- Assuming a full charge will last all night without measuring your CPAP’s actual draw.
Recommended Gear
- Kill-A-Watt P4400 Electricity Usage Monitor: Plug it between a wall outlet and an appliance to measure real watt and watt-hour use over time instead of relying on labels. View on Amazon
- Heavy-duty outdoor extension cord rated for the load: Helps connect the station to appliances safely when outlets are not nearby. View on Amazon
FAQ
Can the EcoFlow Delta Pro 3600 W run a whole house?
Generally no. Whole-house backup requires a much larger system or a transfer switch with a generator. The unit is better suited to critical circuits such as refrigeration, medical devices and communications.
How do I know if my CPAP will run through the night?
Check the machine’s rated wattage and your typical nightly hours, then convert to watt-hours and add a margin. Confirm details with your sleep provider or equipment supplier.
Should I add solar to the setup?
Solar helps on multi-day outages by recharging the battery. Read more in Solar Panels for EcoFlow Delta Pro: How to Choose and Connect Them (2026) before buying panels.
Conclusion
To size an EcoFlow Delta Pro 3600 W for home backup, list only the loads you must keep running, convert each to daily watt-hours, and add a safety margin. Compare that total against the unit’s capacity and check surge ratings for motor-driven appliances. For sizing details across models, see Ecoflow Delta Pro 3600w Explained: Sizing a Home Backup Setup for Outages (2026). For medical equipment, consult your provider or an electrician before relying on backup power.

