Updated November 2026

Home backup power options range from small portable power stations to whole-house generators, and the right choice depends on what you need to keep running. This guide shows you how to total up your essential loads, estimate how many watt-hours you need, and pick a system that covers your critical appliances for the length of a typical outage.

Step 1: List the Loads You Actually Need

Start with the appliances that matter during an outage. A refrigerator, a CPAP machine, a sump pump, a few lights, and a phone charger cover most households. Skip the electric range, clothes dryer, and central air unless you plan to run a much larger system.

Shopping for one? See our guide: Top 5 EcoFlow Power Stations with Solar Panel Options for Home Backup (2026).

Check the nameplate on each device for its wattage. Running power is what the device draws continuously. Starting power, the brief surge when a motor or compressor kicks on, can be two to three times higher, so your system needs enough surge capacity to handle it.

Step 2: Convert Loads into Watt-Hours

Multiply each device’s wattage by the hours it will run per day, then add the totals. A refrigerator rated at 150 watts that runs about 8 hours a day uses roughly 1,200 watt-hours. A CPAP at 60 watts for 8 hours uses about 480 watt-hours. A sump pump drawing 800 watts for 20 minutes an hour during heavy rain adds a meaningful share on its own.

Add a 20 percent buffer for conversion losses and battery aging. If your essential loads total 2,000 watt-hours per day, look for a system with at least 2,400 watt-hours of usable capacity.

Step 3: Compare the Main Backup Options

Each category suits a different situation. The table below summarizes the common choices.

Option Best for Typical limitation
Portable power station Fridge, CPAP, lights, phones Limited runtime without recharging
Portable power station with solar panels Multi-day outages Needs sunlight and panel setup
Standby or portable gas generator High-wattage loads, long outages Fuel storage, noise, ventilation rules
Whole-home battery system Whole-house coverage Higher installation complexity

If you want a simpler starting point, compare a few specific models in Top 5 Home Emergency Battery Backup Power Picks for Outages (2026) before deciding on capacity.

Step 4: Plan Recharging and Surge Capacity

Battery capacity only matters if you can refill it. Solar input is the most common recharge path for portable systems, so check the maximum solar input wattage and whether the unit accepts panels from the same brand. Owners often report that generator or car charging works as a backup during cloudy stretches, but confirm the charging rate before relying on it.

Confirm the inverter’s continuous and surge ratings. A sump pump with a high startup draw can trip an undersized inverter even when the battery still has plenty of charge.

Common Mistakes

  • Sizing only for the average load and ignoring motor startup surges.
  • Forgetting that a CPAP or medical device may need a dedicated plan. Consult your medical provider before relying on any backup for life-support equipment.
  • Assuming a battery rated in watt-hours delivers its full value. Usable capacity is usually lower.
  • Running a gas generator indoors or in a garage. Carbon monoxide can build up quickly.
  • Skipping a test run. Power on the system and run your real loads for an hour before the storm season.

A simple plug-in watt meter helps you measure actual consumption of your fridge and CPAP instead of relying on nameplate estimates. View on Amazon

A heavy-duty extension cord rated for your loads keeps connections safe when running appliances from a portable unit. View on Amazon

A battery-powered or solar-compatible LED lantern covers lighting once the main loads are prioritized. View on Amazon

FAQ

How long will a portable power station run a refrigerator?

A typical refrigerator uses roughly 1,000 to 1,500 watt-hours per day, so a 2,000 watt-hour unit may run it for about a day and a half. Actual runtime depends on the fridge’s efficiency and how often the door opens.

Can I run a sump pump on a portable power station?

Yes, if the inverter’s surge rating covers the pump’s startup draw. Check the pump’s nameplate and the station’s surge specification before connecting it.

Do I need a licensed electrician to install a whole-home system?

Yes, in most cases. A transfer switch or integration with your panel typically requires a licensed electrician and local permits to meet code.

Conclusion

The best home backup power option is the one that covers your essential loads for the outage length you expect. Total your watt-hours, add a buffer for losses, and confirm surge and recharge capacity. Consult a qualified electrician or medical provider for installation and life-support needs.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our solar generators for home backup & emergencies guides, checking product details against manufacturer specifications and owner feedback.