Updated November 2026
The ecoflow delta pro 3600w is a portable power station rated around 3,600 watt-hours of stored energy, with an inverter output that can run common household loads during a power outage. This guide shows you how to match that capacity to the appliances you actually need, estimate how long they will run, and avoid the most common sizing mistakes.
Step 1: List the Loads You Need to Keep Running
Start with a short list rather than your whole house. Most people who use a station like this during outages focus on a few essentials: a refrigerator, a CPAP machine, a sump pump, a router and a few lights. Each one has a power rating printed on its label or in the manual, usually in watts, and some also list amps at 120 volts.
Shopping for one? See our guide: 7 Best EcoFlow Delta Pro Ultra Battery Options Compared (2026).
Two numbers matter for each item. The first is running watts, the steady draw while the device operates. The second is surge watts, a brief spike when a motor starts, which is especially important for refrigerators and sump pumps.
Step 2: Convert Watts to Watt-Hours and Estimate Runtime
Watt-hours tell you how much energy a load consumes over time. Multiply the average wattage by the hours you expect to run it, then add everything together. Remember that a power station cannot deliver its full rated capacity; inverter conversion and battery management losses typically reduce usable energy, so plan on using roughly 85 to 90 percent of the nominal figure.
| Load | Typical Average Draw | Daily Energy Estimate |
|---|---|---|
| Refrigerator (duty-cycled) | About 50 to 150 W average | About 1.2 to 3.6 kWh per day |
| CPAP machine | About 30 to 60 W | About 0.3 to 0.6 kWh for an 8-hour night |
| Sump pump (1/3 HP) | About 500 to 800 W while running | Depends on how often it cycles |
| Wi-Fi router and modem | About 15 to 30 W | About 0.4 to 0.7 kWh per day |
Use these figures only as starting points. Check the labels on your own equipment or a plug-in watt meter for better numbers. Refrigerators in particular vary widely with age, settings and ambient temperature.
Example Calculation
Suppose you want to run a refrigerator for 24 hours at an average of 100 W, a CPAP for 8 hours at 40 W, and a router for 24 hours at 20 W. That totals 2.4 kWh, 0.32 kWh and 0.48 kWh, or about 3.2 kWh per day. Against roughly 3.1 to 3.2 kWh of usable energy, you would get about one day of runtime, so you would need either solar recharging or additional battery capacity for longer outages.
Step 3: Check Surge Capacity and Inverter Limits
Running watts are not the only constraint. Confirm that the continuous output rating of the station covers all loads running at the same moment, with headroom. Then check the surge rating against the highest startup spike, which for a sump pump or refrigerator compressor can be several times its running draw. Running a heavy motor alongside a space heater or electric cooktop will often trip the protection circuits, so plan to stagger large loads.
Step 4: Plan Recharging for Multi-Day Outages
For outages longer than a single charge can cover, recharging matters as much as capacity. Wall charging is fastest when grid power is available, but during an outage you will likely rely on solar input or a generator. Solar panels connected to the station can extend runtime indefinitely in good sunlight, though output depends on panel wattage, orientation and weather. Keep your essential loads on a separate circuit where possible so you can shed nonessential draw during cloudy stretches.
Common Mistakes
- Forgetting that rated capacity is not fully usable energy.
- Ignoring surge watts for refrigerators and sump pumps.
- Assuming a refrigerator runs continuously at its label wattage.
- Skipping a backup plan for recharging during multi-day outages.
- Plugging large heaters or cooktops into the same circuit as medical equipment.
Recommended Gear
A plug-in watt meter helps you measure real consumption of each appliance rather than relying on label estimates. View on Amazon
A heavy-duty extension cord rated for the expected load keeps connections safe when the station sits away from your appliances. View on Amazon
FAQ
Can the ecoflow delta pro 3600w run a whole house?
Usually not for an entire home without a dedicated transfer setup and careful load management. It is generally better suited to a short list of essential circuits, such as a refrigerator, medical device and lights.
How do I know if my refrigerator will work with it?
Check the running wattage and surge rating on the refrigerator label, then compare both against the station’s continuous and surge output specifications. Leave margin for startup spikes.
Should I consult a professional before wiring it into my home?
Yes. Connecting any backup power source to household wiring requires a licensed electrician to ensure proper isolation and code compliance.
Conclusion
Sizing the ecoflow delta pro 3600w starts with a short list of essential loads, their running and surge watts, and realistic daily energy needs. Apply a usable-capacity margin, plan recharging for longer outages, and verify your setup with a qualified electrician if you plan permanent connections.

