Updated November 2026

A stirling solar power generator is a term people use when they are searching for a solar-charged backup power source, but the phrase covers two different things: Stirling engines that run on heat, and the battery-based solar generators most homeowners actually buy for outages. This guide explains the difference, then walks you through sizing a battery-based unit so it can carry a refrigerator, a CPAP machine and a sump pump through a power cut.

Stirling Engines and Battery Solar Generators Are Not the Same

A Stirling engine is a closed-cycle engine that converts heat into mechanical motion by cycling a sealed gas between hot and cold areas. Some designs are paired with solar concentrators to generate electricity directly from sunlight. These systems are mostly used in research, off-grid demonstrations and specialized industrial settings, and they are rarely sold as plug-in backup units for a home.

Shopping for one? See our guide: Jackery Solar Generator Home Power 3000: 4 Best Options Compared (2026).

A solar generator, by contrast, is a battery pack with an inverter and charge controller. Solar panels or a wall outlet charge the battery, and the inverter converts stored energy to standard 120-volt AC. For emergency home power, this is almost always what people need. If you are shopping, look for products described as portable power stations or solar generators, and check the watt-hour capacity rather than the marketing name.

Step 1: Add Up the Watt-Hours You Need

Battery capacity is measured in watt-hours (Wh). To estimate what you need, multiply each device’s wattage by the hours it will run per day, then total the results. Appliance nameplates usually list wattage, but compressor appliances like refrigerators cycle on and off, so their real average draw is lower than the label suggests. Measure actual consumption with a plug-in watt meter where you can.

Typical starting points, based on figures manufacturers commonly publish:

  • Refrigerator: roughly 100 to 800 Wh per day, depending on size and efficiency.
  • CPAP machine: often around 30 to 60 Wh per night, depending on settings and humidifier use.
  • Sump pump (1/3 HP): a few hundred watts while running, but only a few hours per day in heavy rain.

Step 2: Account for Inverter Losses and Surge Power

Inverters are not perfectly efficient, so expect to lose roughly 10 to 20 percent of stored energy in conversion. Divide your total watt-hours by about 0.85 to build in that margin. Also check surge rating: motors like sump pumps and refrigerator compressors briefly draw several times their running wattage at startup. The generator’s continuous output must cover running loads, and its surge rating must cover startup spikes. For a deeper explanation, see Surge vs Continuous Power: What Your Solar Generator Can Actually Start.

Step 3: Plan for Recharging

A battery sized correctly still fails if it never recharges. Solar input is measured in watts, and real-world output is often well below the panel’s rating because of weather, shade and angle. Estimate how many sun hours your location gets on a poor day, not a good one. If your charging is slow, Why Is My Solar Generator Charging Slowly? Causes and Fixes covers the common causes.

Quick sizing table

Load Typical daily use Planning note
Refrigerator 100 to 800 Wh Measure with a watt meter
CPAP 30 to 60 Wh per night Confirm with your device label
Sump pump Varies with rainfall Plan for surge at startup

Common Mistakes to Avoid

  • Sizing to the nameplate wattage instead of measured daily use.
  • Ignoring inverter losses and battery depletion limits.
  • Forgetting surge demand from pumps and compressors.
  • Assuming a full sunny day of charging during a multi-day storm.
  • Running medical equipment without a tested backup plan.

A plug-in watt meter makes the sizing math far more accurate than guessing from labels: View on Amazon. A portable solar panel kit helps extend runtime during multi-day outages: View on Amazon. A heavy-duty extension cord rated for outdoor use keeps connections safe when running appliances from the unit: View on Amazon.

FAQ

Is a Stirling engine a practical home backup option?

For most homeowners, no. Stirling systems are specialized and rarely sold as plug-in backup units, so a battery-based solar generator is the more practical choice.

How many watt-hours do I need for a refrigerator and CPAP overnight?

Add the refrigerator’s daily Wh estimate to roughly 60 Wh for a CPAP night, then add about 20 percent for inverter losses. Measure your actual refrigerator use for the most accurate figure.

Can I run a sump pump from a solar generator?

Often yes, but check the generator’s surge rating against the pump’s startup draw. Consult an electrician if you plan a permanent connection to your home’s wiring.

Conclusion

A stirling solar power generator is best understood as a heat-driven engine, while the practical home backup choice is a battery-based solar generator. Size yours by measuring watt-hours, adding margin for inverter losses, and checking surge capacity. Verify your plan against the manufacturer’s specifications before an outage happens.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our solar generators for home backup & emergencies guides, checking product details against manufacturer specifications and owner feedback.