Updated November 2026
The jackery solar generator 2000 plus kit can keep essential home loads running during a power outage, but only if you match its capacity to what you actually need to power. This guide walks you through totaling your critical loads in watt-hours, checking how long the battery will last, and deciding how many solar panels you need to recharge it.
Step 1: List Only the Loads You Need During an Outage
Start by deciding what must keep running. Whole-house backup is rarely practical with a portable kit, so focus on a short list: a refrigerator, a CPAP machine, a sump pump, a few lights and phone chargers, and perhaps a Wi-Fi router. Anything with a heating element, such as an electric stove, dryer or space heater, will drain a battery quickly and is usually better left off the list.
Shopping for one? See our guide: Jackery HomePower 3600 Plus Solar Generator: 5 Best Picks Compared (2026).
Step 2: Calculate Watt-Hours for Each Device
Every appliance has a wattage rating on its label or in its manual. Multiply that wattage by the hours you expect to run it per day to get watt-hours (Wh). Compressors cycle on and off, so a refrigerator typically averages well below its peak draw. Check the appliance’s energy use label, or use a plug-in power meter for a more accurate daily figure.
| Device | Typical Running Watts | Hours Per Day (Example) | Daily Watt-Hours (Example) |
|---|---|---|---|
| Refrigerator (average) | 60–150 W | 8–10 hours effective | About 500–1,000 Wh |
| CPAP machine | 30–60 W | 8 hours | About 240–480 Wh |
| Sump pump (1/3 HP) | 600–800 W | 0.5 hours | About 300–400 Wh |
| LED lights (5 bulbs) | 40 W total | 5 hours | About 200 Wh |
These figures are estimates for planning. Your own appliances may differ, so verify with the labels or a power meter.
Step 3: Estimate Runtime and Account for Losses
Add your daily watt-hours together, then compare the total to the kit’s usable capacity. Batteries and inverters lose some energy during conversion, so plan on using roughly 80 to 85 percent of the rated capacity in practice. If your critical loads total around 1,000 Wh per day and the usable capacity is about 1,700 Wh, you can expect roughly a day and a half of runtime before needing a recharge.
Step 4: Size the Solar Panels for Recharging
Solar recharging depends on panel wattage, sun hours and weather. A common rule is to divide your daily watt-hours by about 4 to 5 sun hours to estimate the panel wattage you need, then add extra capacity for cloudy days and panel angle losses. Manufacturers specify maximum input ratings for their solar charging, so do not exceed them. For an outage that might last several days, plan for panels that can refill the battery in a single sunny day.
Common Mistakes to Avoid
- Using the peak wattage of a motor for the full runtime. Starting surges are brief, but continuous draw matters more for the calculation.
- Forgetting phantom loads, such as chargers and routers that run around the clock.
- Assuming full solar input in winter or on overcast days.
- Skipping a test run. Power up your real appliances once before you need them.
- Ignoring the kit’s maximum output rating when adding devices.
Recommended Gear
- Plug-in power meter: A meter shows the real daily watt-hours your fridge or CPAP uses, which beats guessing from labels. View on Amazon
- Extension cord rated for outdoor use: Useful for running cords safely from the generator to appliances in another room. View on Amazon
- Surge protector with power switch: Helps protect sensitive electronics when power returns. View on Amazon
FAQ
Can the jackery solar generator 2000 plus kit run a refrigerator all night?
Often yes, for a refrigerator that averages around 1 kWh per day or less. Check the appliance’s energy rating and your kit’s usable capacity to confirm whether it lasts through the night and into the next day.
How do I know if my sump pump will drain the battery too fast?
Sump pumps draw high wattage while running but only for short periods. Estimate how many minutes it runs per day and multiply by its wattage; a pump that runs a few times a day usually uses far less energy than a refrigerator.
Should a CPAP be on the same circuit as other devices?
Keep your CPAP on its own outlet and avoid overloading the inverter with other high-draw devices. If you rely on a CPAP for health reasons, consult your doctor or sleep specialist about backup power planning.
Conclusion
Total only the loads you truly need, convert them to daily watt-hours, and compare that total to the kit’s usable capacity with a margin for losses. Then size your solar input so the battery can recharge within your typical sun hours. A little math before an outage makes the difference between a comfortable night and an empty battery.

